To install a power supply into the system, you would need wires for the connection both to the loads and to the energy source. There are a couple of points that should be taken into consideration when choosing wires, one is current rating, it may cause high heat on the wires or burnt out in the worst case, if the rating is not enough. The other is voltage drop, there would be voltage reduction at load side as current moves through the wires owing to the internal resistance. If too much voltage drop in line, there could be no sufficient voltage to drive the loads. You can find the right wires for use by referring to the table below on the basis of your system design.
CONTACT US ! Company: Foshan shunde guanyuda power supply co., Ltd
Address: Xichong Complex, Lunjiao Town, Shunde District, Foshan Town, Guangdong Province, China
TEL: +86-757-27736306 13825571248
Fax: +86-757-27725706
Email: winnie@gve-cn.com
skype: gvewinnie
wechat: gvewinnie
